Young's Modulus (OCR AS Physics)

• The Young modulus is defined as

The measure of the ability of a material to withstand changes in length with an added load 

• This gives information about the elasticity of a material ie. how stiff a material is
• The Young Modulus, E, can be calculated from the ratio of stress and strain

• Its unit is the same as stress: Pa (since strain is unitless)
• Just like the Force-Extension graph, stress and strain are directly proportional to one another for a material exhibiting elastic behaviour

A stress-strain graph is a straight line with its gradient equal to Young modulus

• The gradient of a stress-strain graph when it is linear is equal to the Young Modulus

Aims of the Experiment

• The aim of the experiment is to measure the Young Modulus of a metal wire
• This requires a clamped horizontal wire over a pulley
• This experiment can also be done with a vertical wire attached to the ceiling with a mass attached

• Independent variable = Force (or load) (N)
• Dependent variable = Extension (m)
• Control variables:
  • The original length of wire
  • The thickness of the wire
  • The metal used for the wire

Equipment List

• Resolution of measuring equipment:
  • Metre ruler = 1 mm

Method

This method is an example of the procedure for varying load and measuring the extension of a copper wire. This is just one way of measuring the relationship between them

1. Measure the diameter of the wire with a micrometre screw gauge or digital callipers. Take at least 3 readings and find an average
2. Set up the apparatus so the wire is taut. No masses should be on the mass hanger just yet
3. Measure the original length of the wire using a metre ruler and mark a reference point with tape preferably near the beginning of the scale eg. at 1 cm
4. Record initial reading on the ruler of the reference point
5. Add a 100 g mass onto the mass hanger
6. Read and record the new reading of the tape marker from the meter ruler
7. Repeat this method by adding a 100 g mass (at least 5 – 10 times) and record the new scale reading from the metre ruler

• An example of a table with some possible loads and extensions might look like:

Analysis of Results

1. Determine extension x from final and initial readings

Example table of results:

Table with additional data

2. Plot a graph of force against extension and draw line of best fit

3. Determine gradient of the force v extension graph

4. Calculate cross-sectional area from:

5. Calculate the Young’s modulus from:

Evaluating the Experiment

Systematic Errors:

• Use a vernier scale for more precise readings
  • This is more likely to produce an accurate value for the extension

• If the wire is extended past its elastic limit, it will be permanently deformed
  • To reduce the risk of this, remove the load and check the wire returns to its original length before taking any new readings

• Parallax error from reading the marker on the ruler
• Random errors are reduced by repeating the experiment for all the loads and finding an average extension
• Reduce the uncertainty on the cross-sectional area by measuring the diameter in several places and calculating an average

Safety Considerations

• Wear safety goggles at all times in case the wire snaps
• Make sure a cushion or soft surface is kept directly below the mass hanger, in case it falls off