Thermal Properties & Temperature (Cambridge O Level Physics)

Exam Questions

3 hours45 questions
1a1 mark

A student is investigating how partly covering the surface of the water in a beaker affects the rate at which the water cools.

The apparatus used is shown in Fig. 1.1.

q1-series3

q1a-series3
 

 Record the room temperature θR, shown on the thermometer in Fig. 1.2.

 

 

θR = ......................................................... 

1b2 marks

The student pours 100 cm3 of hot water into a beaker. She places lid A on the beaker. This leaves half of the water surface uncovered, as shown in Fig. 1.3.

She records the temperature of the water in the beaker and immediately starts a stopclock.

She records the temperature θ of the water every 30 s. Her readings are shown in Table 1.1.

She repeats the procedure using lid B. This leaves a quarter of the water surface uncovered, as shown in Fig. 1.4.

 
q1b-series3
 

Complete the headings and the time t column in Table 1.1.

  
q1b2-series3
1c1 mark

Describe a precaution that should be taken to ensure that the temperature readings are as accurate as possible in the experiment.

1d4 marks
(i)
Write a conclusion to this experiment, stating for which lid the rate of cooling is greater.
 
Explain your answer by reference to the results.
[2]
   
(ii)
Suggest a change to the apparatus that could produce a greater difference between the rates of cooling for lid A and lid B.
   
Explain why the change might produce a greater difference.  
[2]
1e2 marks

A student suggests that the rate of cooling is directly proportional to the percentage of the uncovered surface area. He wants to draw a graph of cooling rate against the percentage of uncovered area to investigate this.

 

Describe how his graph line will show whether the rate of cooling and the percentage of uncovered surface area are directly proportional.

1f1 mark

Students in other countries carry out the same experiment.

 

Suggest one factor that they should keep the same if they are to obtain similar readings.

Did this page help you?

2a1 mark

A student is investigating the cooling of water.

Fig. 2.1 shows the apparatus used.

q2-series2

The thermometer in Fig. 2.2 shows room temperature θR at the beginning of the experiment.

Record θR.

q2a-series2
 
 
θR = ......................................................... 
2b7 marks

The student pours 200 cm3 of hot water into the beaker.

 

He records the temperature θH of the hot water at time t = 0 and immediately starts a stopclock.

 
He continues recording the temperature readings every 30 s. The readings are shown in Table 2.1.

 
(i)

Explain why the student should wait a few seconds after placing the thermometer in the hot water before taking the first temperature reading.

[1]

 

(ii)
Complete the column headings in Table 2.1.
[1]
 
(iii)
Complete the time column in Table 2.1.
[1]
q2biii-series2
 
(iv)
Plot a graph of θ/ °C (y-axis) against t/s (x-axis). You do not need to start the y-axis at the origin (0,0) but the value of room temperature θR must be marked on the y-axis.
 
q2biv-series2
[4]
2c1 mark

Draw a horizontal line across the graph grid to indicate the value of room temperature θR, as shown by the thermometer in Fig. 2.2.

2d2 marks

State two precautions that you would take in order to obtain accurate readings in this experiment.

2e1 mark

A student plans to repeat the experiment using the same thermometer and the same volume of water.

 

Suggest two changes to the apparatus or the procedure that would increase the rate of cooling of the water.

Did this page help you?