Physical Quantities & Measurement Techniques (Cambridge O Level Physics)

Exam Questions

3 hours38 questions
1
Sme Calculator
1 mark

Five identical spheres are placed between two blocks in order to measure their diameter.

q1-easy-mcq-1-1--physical-quantities-and-measurement-techniques-cie-igcse-physics

What is the diameter of a single sphere?

  • 2.2 cm

  • 2.0 cm

  • 2.1 cm

  • 2.3 cm

Did this page help you?

2
Sme Calculator
1 mark

A student wants to take a particularly accurate measurement of the volume of liquid in a measuring cylinder.

Which of the following procedures would make her measurement less accurate?

  • Putting her eyes level with the height of the measurement to be taken.

  • Reading the liquid level from the bottom of the meniscus.

  • Using the largest measuring cylinder she could find.

  • Using a set-square to make sure the cylinder is perfectly vertical.

Did this page help you?

3
Sme Calculator
1 mark

A student is timing the rate of cooling of a beaker of water. On a repeat run of the investigation, the student forgets to zero the stopwatch.

The readings on the stopwatch at the start time and the end time are shown in Fig. 1.1

1-1-3e-measuring-time-stopwatch

Calculate how long it took the beaker to cool.

  • 11 minutes

  • 11 minutes and 8 seconds

  • 12 minutes

  • 12 minutes and 8 seconds

Did this page help you?

4
Sme Calculator
1 mark

Identify the physical quantity that is not scalar.

  • speed

  • time

  • weight

  • energy

Did this page help you?

5
Sme Calculator
1 mark

Identify the physical quantity that is scalar.

  • weight

  • distance

  • velocity

  • acceleration

Did this page help you?

1
Sme Calculator
1 mark

I wish to roast a chicken for Sunday lunch. The chicken requires 1 hour and 20 minutes in the oven to be properly cooked.

The oven must be switched on 10 minutes before any food is put in, in order to pre-heat, and reach the correct temperature for cooking.

I wish the chicken to be ready at 4:30pm. At what time must I switch the oven on?

  • 2:10pm

  • 3:10pm

  • 2:00pm

  • 3:00pm

Did this page help you?

2
Sme Calculator
1 mark

A particularly diligent student wants to measure the volume of some liquid for an experiment. She has two measuring cylinders available, a large 250 ml one and a small 50 ml one. The liquid will fit into either of the two measuring cylinders.

As expected, the liquid forms a meniscus where it touches the sides of either measuring cylinder.

Which cylinder should the student use to get the most accurate result, and from where should she measure the liquid level?

  Measuring cylinder Reading taken from
A large Top of meniscus
B large Bottom of meniscus
C small Top of meniscus
D small Bottom of meniscus

    Did this page help you?

    3
    Sme Calculator
    1 mark

    A geologist wants to measure the volume of a particularly interesting pebble she has found in a river.

    She uses the apparatus shown below.

    q3-medium-mcq-1-1--physical-quantities-and-measurement-techniques-cie-igcse-physics

    What is the volume of the pebble?

    • 11 cm3

    • 23 cm3

    • 6 cm3

    • 17 cm3

    Did this page help you?

    4
    Sme Calculator
    1 mark

    A scientist is trying to determine the volume of three identical pieces of a new material. She places them in a measuring cylinder, as shown in the diagram.

    The first cylinder shows the level of water in the measuring cylinder before the pieces are added, and the second cylinder shows the measuring cylinder with the pieces of the new material inside.

    q4-medium-mcq-1-1--physical-quantities-and-measurement-techniques-cie-igcse-physics

    What is the volume of each piece of the new material?

    •  30.0 cm3

    • 13.3 cm3

    • 16.7 cm3

    • 40.0 cm3

    Did this page help you?

    5
    Sme Calculator
    1 mark

    Which of the diagrams below correctly shows two forces , W and X with their resultant?

    q5-medium-mcq-1-1--physical-quantities-and-measurement-techniques-cie-igcse-physics

      Did this page help you?

      6
      Sme Calculator
      1 mark

      A small cylinder is rolled along a ruler and completes two full turns as shown in the diagram.

      q1-cie-ol-physics-specimen-paper-1-mcq

      What is the circumference of the cylinder?

      • 4.4cm

      • 5.1cm 

      • 8.8cm

      • 10.2cm

      Did this page help you?

      7
      Sme Calculator
      1 mark

      A list of various quantities is shown. 

      acceleration 

      displacement
       
      force 

      length
       
      mass
       
      velocity
       

      How many of these quantities are vectors? 

      • 2

      •  3 

      •  5 

      Did this page help you?

      8
      Sme Calculator
      1 mark

      Which diagram shows the vector addition of a 4.0N force and a 3.0N force?

      q2-cie-ol-physics-specimen-paper-1-mcq

        Did this page help you?

        9
        Sme Calculator
        1 mark

        A student determines the circumference of a football. 

        Which instrument gives a reading that is the circumference of the football?

        • calipers

        • micrometer

        • rule

        •  tape

        Did this page help you?

        1
        Sme Calculator
        1 mark

        Three blocks are placed into three measuring cylinders. These are shown below.

        q1-hard-mcq-1-1--physical-quantities-and-measurement-techniques-cie-igcse-physics

        Which row in the table shows the blocks in order of increasing volume?

          Smallest
        volume
        Largest volume
        A X Y Z
        B Y X Z
        C Z Y X
        D Z X Y

          Did this page help you?

          2
          Sme Calculator
          1 mark

          A student is trying to see how quickly they can run 5.0 km on a standard 400 m running track.

          They reason that, if they know how fast they can run one lap, they can assume they will run at the same speed for 5.0 km, and can calculate their predicted time.

          They, correctly, reason that they will not be able to maintain their initial pace throughout the whole 5.0 km, so they decide to time lap 5.

          The diagram shows the reading on the stopwatch at the beginning and the end of lap 5.

          q2-hard-mcq-1-1--physical-quantities-and-measurement-techniques-cie-igcse-physics

          Calculate how long it should take the student to run 5.0 km.

          • 36 minutes 52.5 seconds

          • 24 minutes 22.5 seconds

          • 13 minutes 0 seconds

          • 9 minutes 45 seconds

          Did this page help you?

          3
          Sme Calculator
          1 mark

          An Olympic cyclist rides round a velodrome track 5 times.

          The diagram below shows the reading on the stopwatch which was used to time the laps. Unfortunately, the person using the stopwatch started it a little early.

          q3-hard-mcq-1-1--physical-quantities-and-measurement-techniques-cie-igcse-physics

          What is the average time to complete one lap of the velodrome?

          • 16.24 s

          • 14.04 s

          • 15.84 s

          • 15.21 s

          Did this page help you?

          4
          Sme Calculator
          1 mark

          A student uses a ruler to determine the circumference of a wooden dowel.

          She puts a mark onto the dowel, then rolls it along the ruler three times, before reading the position on the ruler at which it stopped.

          q4-hard-mcq-1-1--physical-quantities-and-measurement-techniques-cie-igcse-physics

          What is the circumference of the dowel?

          • 12 cm

          • 12.3 cm

          • 37 cm

          • 36 cm

          Did this page help you?

          5
          Sme Calculator
          1 mark

          Two forces act on an object at right angles to each other: a 6 N force and an 8 N force.

          The diagrams below show the two forces.

          Which diagram also shows the correct resultant force?

          q5-hard-mcq-1-1--physical-quantities-and-measurement-techniques-cie-igcse-physics

            Did this page help you?