Physical Quantities & Measurement Techniques (CIE IGCSE Physics: Co-ordinated Sciences (Double Award))

Topic Questions

2 hours28 questions
11 mark

Five identical spheres are placed between two blocks in order to measure their diameter.

q1-easy-mcq-1-1--physical-quantities-and-measurement-techniques-cie-igcse-physics

What is the diameter of a single sphere?

  • 2.2 cm

  • 2.0 cm

  • 2.1 cm

  • 2.3 cm

Did this page help you?

21 mark

A student wants to take a particularly accurate measurement of the volume of liquid in a measuring cylinder.

Which of the following procedures would make her measurement less accurate?

  • Putting her eyes level with the height of the measurement to be taken.

  • Reading the liquid level from the bottom of the meniscus.

  • Using the largest measuring cylinder she could find.

  • Using a set-square to make sure the cylinder is perfectly vertical.

Did this page help you?

31 mark

A student is timing the rate of cooling of a beaker of water. On a repeat run of the investigation, the student forgets to zero the stopwatch.

The readings on the stopwatch at the start time and the end time are shown in Fig. 1.1

1-1-3e-measuring-time-stopwatch

Calculate how long it took the beaker to cool.

  • 11 minutes

  • 11 minutes and 8 seconds

  • 12 minutes

  • 12 minutes and 8 seconds

Did this page help you?

41 mark

Extended tier only

 

Identify the physical quantity that is not scalar.

  • speed

  • time

  • weight

  • energy

Did this page help you?

51 mark

Extended tier only

 

Identify the physical quantity that is a scalar.

  • weight

  • distance

  • velocity

  • acceleration

Did this page help you?

11 mark

A person wishes to roast a chicken. The chicken requires 1 hour and 20 minutes in the oven to be properly cooked.

The oven must be switched on 10 minutes before any food is put in, in order to pre-heat, and reach the correct temperature for cooking.

The chicken needs to be ready at 4:30 pm. At what time must the oven be switched on?

  • 2:10 pm

  • 3:10 pm

  • 2:00 pm

  • 3:00 pm

Did this page help you?

21 mark

A particularly diligent student wants to measure the volume of some liquid for an experiment. She has two measuring cylinders available, a large 250 ml one and a small 50 ml one. The liquid will fit into either of the two measuring cylinders.

As expected, the liquid forms a meniscus where it touches the sides of either measuring cylinder.

Which cylinder should the student use to get the most accurate result, and from where should she measure the liquid level?

  Measuring cylinder Reading taken from
A large Top of meniscus
B large Bottom of meniscus
C small Top of meniscus
D small Bottom of meniscus

    Did this page help you?

    31 mark

    A geologist wants to measure the volume of a particularly interesting pebble she has found in a river.

    She uses the apparatus shown below.

    q3-medium-mcq-1-1--physical-quantities-and-measurement-techniques-cie-igcse-physics

    What is the volume of the pebble?

    • 11 cm3

    • 23 cm3

    • 6 cm3

    • 17 cm3

    Did this page help you?

    41 mark

    A scientist is trying to determine the volume of three identical pieces of a new material. She places them in a measuring cylinder, as shown in the diagram.

    The first cylinder shows the level of water in the measuring cylinder before the pieces are added, and the second cylinder shows the measuring cylinder with the pieces of the new material inside.

    q4-medium-mcq-1-1--physical-quantities-and-measurement-techniques-cie-igcse-physics

    What is the volume of each piece of the new material?

    •  30.0 cm3

    • 13.3 cm3

    • 16.7 cm3

    • 40.0 cm3

    Did this page help you?

    11 mark

    Three blocks are placed into three measuring cylinders. These are shown below.

    q1-hard-mcq-1-1--physical-quantities-and-measurement-techniques-cie-igcse-physics

    Which row in the table shows the blocks in order of increasing volume?

      Smallest
    volume
    Largest volume
    A X Y Z
    B Y X Z
    C Z Y X
    D Z X Y

      Did this page help you?

      21 mark

      A student is trying to see how quickly they can run 5.0 km on a standard 400 m running track.

      They reason that, if they know how fast they can run one lap, they can assume they will run at the same speed for 5.0 km, and can calculate their predicted time.

      They, correctly, reason that they will not be able to maintain their initial pace throughout the whole 5.0 km, so they decide to time lap 5.

      The diagram shows the reading on the stopwatch at the beginning and the end of lap 5.

      q2-hard-mcq-1-1--physical-quantities-and-measurement-techniques-cie-igcse-physics

      Calculate how long it should take the student to run 5.0 km.

      • 36 minutes 52.5 seconds

      • 24 minutes 22.5 seconds

      • 13 minutes 0 seconds

      • 9 minutes 45 seconds

      Did this page help you?

      31 mark

      An Olympic cyclist rides around a velodrome track 5 times.

      The diagram below shows the reading on the stopwatch, which was used to time the laps. Unfortunately, the person using the stopwatch started it a little early, so the stopwatch reads 2 seconds when the cyclist starts.

      q3-hard-mcq-1-1--physical-quantities-and-measurement-techniques-cie-igcse-physics

      What is the average time to complete one lap of the velodrome?

      • 16.24 s

      • 14.04 s

      • 15.84 s

      • 15.21 s

      Did this page help you?

      41 mark

      A student uses a ruler to determine the circumference of a wooden dowel.

      She puts a mark onto the dowel, then rolls it along the ruler three times, before reading the position on the ruler at which it stopped.

      q4-hard-mcq-1-1--physical-quantities-and-measurement-techniques-cie-igcse-physics

      What is the circumference of the dowel?

      • 12 cm

      • 12.3 cm

      • 37 cm

      • 36 cm

      Did this page help you?