Core Practical: Investigating Specific Heat Capacity (Edexcel IGCSE Physics)

Core practical 11: investigating specific heat capacity

Aims of the experiment

• This experiment aims to determine the specific heat capacity of a solid and of water by measuring the energy required to increase the temperature of a known amount by one degree

Variables

• Independent variable = Time, t

• Dependent variable = Temperature, T

• Control variables:

  • Potential difference from the power supply, V

Equipment

Equipment list for the specific heat capacity practical

• Resolution of measuring equipment:

  • Thermometer = 0.1 °C

  • Voltmeter = 0.1 V

  • Ammeter = 0.1 A

  • Stopwatch = 0.01 s

  • Digital balance = 0.1 g

Method

The experiment set up for the specific heat capacity practical

Apparatus for heating water and measuring energy supplied

1. Place the beaker on the digital balance and press 'zero'

2. Add approximately 250 ml of water and record the mass of the water using the digital balance

3. Place the immersion heater and thermometer in the water

4. Connect up the circuit as shown in the diagram, with the ammeter in series with the power supply and immersion heater, and the voltmeter in parallel with the immersion heater

5. Record the initial temperature of the water at time 0 s

6. Turn on the power supply, set it at approximately 10 V, and start the stopwatch

7. Record the voltage from the voltmeter and the current from the ammeter

8. Continue to record the temperature, voltage and current every 60 seconds for 10 minutes

9. Repeat steps 2-8, replacing the beaker of water for the solid block of aluminium and starting with recording its mass using the digital balance

Results

An example of a results table for the specific heat capacity practical

An example of a suitable results table for the specific heat capacity experiment looks like this. Energy supplies = voltage x current x time.

Analysis of specific heat capacity practical results

• Calculate the energy supplied every 60 seconds using the electrical energy transfer formula:

  Electrical energy = voltage × current × time

• This formula is explained in the Calculating energy transfers revision note

• Calculate the temperature change by subtracting the temperature at time 0 s from the temperature recorded each minute

• Then use the specific heat capacity equation to calculate the specific heat capacity of the material

  • The specific heat capacity equation is explained in the revision note Specific heat capacity

• Plot a graph of the energy supplied (y-axis) against the temperature change multiplied by the average mass (x-axis)

• Calculate the gradient of this graph in the straight line region to obtain the specific heat capacity of the water or solid block

An example graph for the specific heat capacity practical

The gradient of the graph is equal to the specific heat capacity of the substance, assuming a perfectly efficient immersion heater

Evaluating the specific heat capacity practical

Systematic Errors:

• Ensure the digital balance is set to zero before taking measurements of mass

• Some water may be lost to the surroundings by evaporation. Calculate an average mass of water (using the mass before the experiment and the mass after) to account for this

• Remember to only take gradients on the straight-line region

  • Before this point the energy supplied is being used to heat the immersion heater itself

Random Errors:

• Stir the water constantly whilst heating it to ensure the temperature measured is the temperature throughout the fluid

• When the current or voltage values appear to be changing between two values next to one another then be consistent in choosing the higher value

Safety considerations for the specific heat capacity practical

• The immersion heater will get very hot

  • Make sure not to touch it, and have a heatproof mat ready to place it on

• Make sure that the immersion heater is connected to a Direct Current supply

• The beaker may become unstable with an immersion heater and thermometer resting in it

  • If you feel this is the case then use a clamp stand to hold both

• Wear goggles while heating water

• Make sure to stand up during the whole experiment, to react quickly to any spills