Circuit Breakers (WJEC GCSE Physics)

Revision Note

Leander

Author

Leander

Last updated

Circuit Breakers

  • Fuses and circuit breakers are safety devices designed to cut off the flow of electricity to an appliance if the current becomes too large (due to a fault or a surge)
  • Domestic electricity is supplied at 230 V with a maximum current of 65 A
  • The current enters the house at the consumer unit (sometimes referred to as a 'fuse box')
  • The consumer unit consists of a series of circuit breakers which control the amount of current supplied to each circuit within the house

Example of a Domestic Circuit

1-4-domestic-circuit-consumer-unit

The consumer unit distributes current to all the circuits in the house

  • The circuit breakers within the consumer unit provide protection from current surges or faults
  • There are two types of circuit breaker:
    • Miniature circuit breakers (mcb)
    • Residual current circuit breakers (rccb)

Miniature Circuit Breakers

  • Miniature circuit breakers (mcb) control individual circuits, such as:
    • Upstairs plug sockets
    • Downstairs plug sockets
    • Upstairs ceiling lights
    • Downstairs ceiling lights
    • Electrical appliances, such as ovens and showers
  • Each mcb can be switched on or off
  • Each mcb limits the current flowing to its circuit
  • Each mcb protects its circuit from surges or faults
    • If the current rises above the set limit of the mcb, the switch flips to its off position 'breaking' the circuit
  • Miniature circuit breakers can be reset by turning them back to their on position
    • Nothing within the circuit breaker is permanently damaged (unlike a fuse)

Consumer Unit

1-4-consumer-unit

A consumer unit consists of miniature circuit breakers (mcb) which control individual circuits, and residual current circuit breakers (rccb) which protect the household from electrocution

Residual Current Circuit Breakers

  • Residual current circuit breakers (rccb) monitor the difference between the current drawn from the consumer unit and the current returning to it
  • If the difference between the two is greater than the set limit of the rccb, the switch flips to its off position and 'breaks' the circuit
  • Residual current circuit breakers can also be reset by switching them back to their on position

Fuses

  • Fuses are used to protect individual appliances
  • Fuses are located in the plug
  • Fuses usually consist of a glass cylinder containing a thin metal wire
  • If the current in the wire becomes too large:
    • The wire heats up and melts
    • This causes the wire to break, breaking the circuit and stopping the current

Circuit Symbol of a Fuse

Fuse, IGCSE & GCSE Physics revision notes

The circuit symbol for a fuse has a wire running through it (not to be confused with a resistor)

  • Fuses have ratings, which signify the maximum current that can flow through the fuse wire without it melting
  • If the current exceeds that value, the fuse wire melts and the individual appliance is disconnected from the mains supply
  • Fuses come in values of 3 A, 5 A and 13 A
  • The correct fuse to use is the value just above the current required for the appliance

Worked example

Higher Tier

A 2 kW kettle is purchased to be used on the mains supply. 

Determine the value of the fuse required for the kettle.

 

Answer:

Step 1: List the known quantities and convert to SI units

  • Power rating, P = 2 kW = 2000 W
  • Voltage of mains supply, V = 230 V

 

Step 2: Write out the equation

  • The current is needed to determine what fuse to use
  • Therefore, the power, voltage, current equation should be used

P space equals space V I

 

Step 3: Rearrange the equation to make current the subject

  • Divide both sides by V

P over V space equals fraction numerator space up diagonal strike V I over denominator up diagonal strike V end fraction

I space equals fraction numerator space P over denominator V end fraction

 

Step 4: Substitute in the known values to calculate

I space equals fraction numerator space 2000 over denominator 230 end fraction

I space equals space 8.7 space straight A

 

Step 5: State the fuse required for the kettle

  • The correct fuse is slightly higher in value than the current required by the appliance
  • Fuses come in 3 A, 5 A, or 13 A
  • Therefore, the correct fuse is 13 A

Examiner Tip

Foundation students would be given the equation in its rearranged form in the exam question

You've read 0 of your 5 free revision notes this week

Sign up now. It’s free!

Join the 100,000+ Students that ❤️ Save My Exams

the (exam) results speak for themselves:

Did this page help you?

Leander

Author: Leander

Expertise: Physics

Leander graduated with First-class honours in Science and Education from Sheffield Hallam University. She won the prestigious Lord Robert Winston Solomon Lipson Prize in recognition of her dedication to science and teaching excellence. After teaching and tutoring both science and maths students, Leander now brings this passion for helping young people reach their potential to her work at SME.