Electromagnetism & The Motor Effect (Edexcel GCSE Physics)

Exam Questions

1 hour11 questions
1a
Sme Calculator
3 marks

Higher Only

Figure 1 shows a solenoid wrapped around a plastic PVC pipe. A current flows in the coil in the direction of the arrow.

7-2-e-1a-pvcpipe-solenoid

Figure 1

Draw the magnetic field lines around the coil on figure 1 and arrows to show the direction of the field.

1b
Sme Calculator
1 mark

Higher Only

A long soft iron bar is placed inside the PVC pipe.



State the name of the device when current flows in the coil.

1c
Sme Calculator
2 marks

Higher Only

The cross in Figure 2 indicates the current in a wire travelling into the plane of the page. 

screenshot-2023-03-13-at-17-18-54

Figure 2

Draw lines to represent the magnetic field generated by this current.

Did this page help you?

2a
Sme Calculator
2 marks

Higher Only

Figure 1 shows the apparatus used to demonstrate the motor effect.

7-2-e-2a-motor-effect-demo-cell

Figure 1

Q is a piece of copper wire resting on two other wires. A current passes anticlockwise through the circuit.

Describe what happens to wire Q when the current is switched on.

2b
Sme Calculator
1 mark

Higher Only

The direction of the magnetic field is reversed.


Describe any differences in the motion of Q.

2c
Sme Calculator
1 mark

Higher Only

The current is increased.


Describe any differences in the motion of wire Q.

Did this page help you?

3a
Sme Calculator
1 mark

Higher Only

Figure 1 shows a coil that rotates due to a current in the coil and a magnetic field. 

 

7-2-e-3a-motor7-23e-a

Figure 1

State the name of the phenomenon causing this rotation.

3b
Sme Calculator
1 mark

Higher Only

State the direction the left side of the coil moves in the diagram.

3c
Sme Calculator
2 marks

Higher Only

A current of 3.2 A flows in the coil, which is 0.20 m long and the magnetic flux density is 0.05 T.


Calculate the force on the left side of the coil.


Use the correct equation selected from the list of equations at the end of this paper.

  

   

force = .................................... N

Did this page help you?

1a
Sme Calculator
1 mark

Higher Only

 

Figure 11 shows the magnetic field of a magnet.

fig-11-paper2h-june2020-edexcel-gcse-physics

Figure 11

At which point is the magnetic field strongest?

  A  
  B  
  C  
  D  
1b
Sme Calculator
2 marks

Higher Only

 

Figure 12 shows a wire carrying a current. 

fig-12-paper2h-june2020-edexcel-gcse-physics

Figure 12

Draw, on the card in Figure 12, the magnetic field that is produced by the current.

1c
Sme Calculator
6 marks

Higher Only

 

Figure 13 shows two metal rods carrying a current.

A metal roller touches both rods and completes the circuit.
The roller is in the magnetic field produced by a magnet.

fig-13-paper2h-june2020-edexcel-gcse-physics

Figure 13

i)
The magnetic flux density of the magnetic field at the roller is 1.2 T.
The current in the roller is 2.5 A.
The length of the roller carrying the current is 0.060 m.

Calculate the force on the roller.
Use the equation

F = B × I × l

[2]

force on the roller = .............................................................. N

ii)
Describe how Fleming’s left-hand rule can be used to determine the direction of the force acting on the roller.


You may draw a diagram to help your answer.

[3]

iii)
Draw an arrow on Figure 13 to show the direction of the force acting on the roller.

[1]

Did this page help you?

2a2 marks

Figure 6 shows some objects and words describing these objects.

Draw one line from each object to its description.

fig-6-paper2f-oct2021-edexcel-gcse-physics

Figure 6

2b2 marks

Figure 7 shows a wire passing through a piece of card.

The wire carries an electric current.

fig-7-paper2f-oct2021-edexcel-gcse-physics

Figure 7

i)
Draw one magnetic field line on Figure 7, to show the shape of the magnetic field produced by the current.

[1]

ii)
Draw one arrow on the field line you have drawn to show the direction of the magnetic field.

[1]

2c6 marks

A student measures the strength of the magnetic field at several distances from the wire in Figure 7.

Figure 8 shows most of the student’s results.



fig-8-paper2f-oct2021-edexcel-gcse-physics

Figure 8


Figure 9 shows two extra sets of results.

mT is a unit of strength of a magnetic field.

distance from wire in cm strength of magnetic field in mT
1.0 8.1
2.0 3.9

Figure 9

i)
Plot the two extra points on Figure 8.

[2]

ii)
Draw a best fit curve on the graph in Figure 8.

[1]

iii)
Use the graph in Figure 8 to calculate the change in strength of magnetic field when the distance from the wire changes from 4cm to 8 cm.

[2]

change in strength of magnetic field = ................................ mT

iv)
The distance from the wire affects the strength of the magnetic field.

State one other factor that affects the strength of the magnetic field.

[1]

Did this page help you?

3a5 marks
A teacher is demonstrating electromagnetic induction.

 
                                                    
The teacher has a bar magnet, a coil of wire and a sensitive voltmeter.

i)
Draw a diagram to show how the teacher should arrange the apparatus.

[1]

ii)
Explain how the teacher could use this apparatus to demonstrate the factors affecting the size and direction of the induced potential difference.

[4]

3b5 marks

Higher Only

There is a changing magnetic field in the core of a transformer.

i)
Describe the cause of the changing magnetic field in the core of the transformer.

[2]

ii)
A potential difference of 230V is applied across the primary coil of a transformer.
There is a potential difference of 15V across the secondary coil.
The primary coil has 2000 turns.

Calculate the number of turns in the secondary coil.

Use an equation selected from the list of equations at the end of this paper.

[3]

............................................... turns

Did this page help you?

4a2 marks

Higher Only

Figure 1 shows equipment which demonstrates the motor effect.

Figure 1

7-2-e-2a-motor-effect-demo-cell

A piece of copper wire (Q) is placed on two bare wires connected to a cell and switch.

Describe what happens to wire Q when the switch is closed.

4b2 marks

Higher Only

Describe any differences in the motion of Q for the following changes:

(i)
The direction of the magnetic field is reversed.
[1]
 
(ii)
The cell is replaced with a cell of higher voltage. 
[1]
4c3 marks

Higher Only

Figure 2 shows two identical metal bars freely suspended inside a coil of insulated wire.

12-2-m-4c-bars-in-coil

Figure 2

A direct current passes through the coil, then the metal bars move apart.

Explain why the metal bars move apart.

4d3 marks

Higher Only

The d.c. supply is removed and the metal rods return to their starting places.

Suggest a material that the metal rods could be made from. Explain why you chose this.

Did this page help you?

5a1 mark

Higher Only

The coil in Figure 1 is rotating. 

7-2-e-3a-motor7-23e-a

Figure 1

State the name of the phenomenon causing this rotation.

5b1 mark

Higher Only

Using Fleming's left hand rule, state the direction that the left side of the coil moves in Figure 1.

5c2 marks

Higher Only

A current of 2.5 A flows in the coil, which is 0.10 m long and 0.10 m wide.

If the magnetic flux density is 0.10 T, calculate the force on the left side of the coil.  

   

Force = .................................... N
5d2 marks

Higher Only

Explain why a force acts on the coil when a current passes through it.

Did this page help you?

1a
Sme Calculator
2 marks

Figure 1 shows a coil of wires called a solenoid.

12-2-h-1a-solenoid

Figure 1

Figure 2 contains descriptions of the magnetic field. Place a tick () in the correct cells in Figure 2 to identify the properties inside and outside the coil.

  Part of the magnetic field
description of the magnetic field Inside the coil outside the coil
weak    
strong    
non-uniform    
uniform    

Figure 2

1b
Sme Calculator
4 marks

Describe how the student can use plotting compasses to determine the shape of the magnetic field around the coil. 

Did this page help you?

2a
Sme Calculator
1 mark

Higher Only

A current-carrying wire is placed between two magnetic poles as shown in the diagram below. It experiences an upwards force.

12-2-h-2a-flemings-lh-rule-mcq

What is the orientation of the magnetic poles?

 
   Left magnet Right magnet
  square  A N N
  square  B S N
  square  C N S
  square  D S S
2b
Sme Calculator
4 marks

Higher Only

Figure 1 shows a wire connected to a circuit inside a uniform magnetic field.

12-2-h-2b-wire-in-a-field

Figure 1

The magnetic flux density of the field is 0.82 N/A m. 

The length of the wire is 40 mm with 30 mm inside the field. 

The size of the force due to the magnetic field on the wire is 0.073 N.

Calculate

(i)
The size of the current in the wire.
[3]
(ii)
The direction of the force.
[1]
2c
Sme Calculator
2 marks

Higher Only

The circuit in Figure 1 is turned so the wire is now placed horizontally.

Explain the effect this has on the motion of the wire.

Did this page help you?

3a
Sme Calculator
1 mark

A current-carrying wire is placed into a magnetic field as shown in the diagram. The wire experiences a force.

q7-hard-mcq-4-4-electromagnetic-effects-cie-igcse-physics

In which direction is the force?

square   A   PO

square   B   ST

square   C   QR

square   D   OP

3b
Sme Calculator
3 marks

Two long, thin magnets are held with their S-poles facing each other.

The force, F, between the magnets can be calculated using the equation

F space equals fraction numerator space k over denominator d squared end fraction

where 

   k is a constant value

    d is the distance between the magnets.

When the magnets are 3.0 cm apart, the force between the magnets is 1.5 N.

Calculate the separation of the magnets when the force between them is 2.6 N.

3c
Sme Calculator
3 marks

Explain what happens if the magnets are held the same initial distance apart but with the S-pole of one magnet now facing the N-pole of the other magnet.

Did this page help you?