Charge & Current (AQA GCSE Physics)

• For electrical charge to flow through a closed circuit, it must include a source of potential difference (p.d)
• Sources of potential difference include:
  • A cell
  • Batteries (multiple cells)
  • Electrical generator

• A cell makes one end of the circuit positive and the other negative
• This sets up a potential difference across the circuit
  • This is sometimes known as the voltage
  • The symbol for potential difference is V

• The potential difference across a component in a circuit is defined as

The energy transferred per unit charge flowing from one point to another

• The energy transferred can also be called the work done
• This is calculated using the equation:

• Potential difference is measured in volts (V). This is the same as a Joule per coulomb (J C^-1)
  • If a bulb has a voltage of 3 V, every coulomb of charge passing through the bulb will lose 3 J of energy

• Potential difference (or voltage) is measured using a voltmeter
• A voltmeter is always set up in parallel to the component you are measuring the potential difference across

Step 1: Write down the known quantities

• • Charge, Q = 5 C
  • Potential difference, V = 20 V

Step 2: Write down the relevant equation

Step 3: Rearrange for the work done, W

W = VQ

Step 4: Substitute in the values

W = 20 × 5 = 100 J

• Electric current is the flow of electrical charge
  • It is measured in units of amperes (A) or amps
  • The symbol for current is I

• The size of the electric current is the rate of flow of electrical charge
  • In other words, how much charge passes through a point each second

• In metals, such as a copper wire, the electrical charge that flows is electrons
  • Therefore, the current in a circuit is a flow of electrons

In metals, the current is caused by a flow of electrons

• The unit of charge is the Coulomb (C)
  • This is defined as the quantity of charge that passes a fixed point per second when a current of 1 A is flowing

• The coulomb (C), is equal to the quantity of electricity conveyed in one second by a current of one ampere i.e. 1 C = 1 A s
• Charge flow, current and time are related by the equation:

• This equation can be rearranged with the help of the following formula triangle:

Step 1: Write down the known quantities

• • Charge, Q = 4 C
  • Time, t = 500 s

Step 2: Write down the relevant equation

Q = It

Step 3: Rearrange for current, I

Step 4: Substitute in the values

• Electrons are negatively charged
  • Therefore, they flow away from the negative terminal of a cell towards the positive terminal

• Conventional current is defined as the flow of positive charge from the positive terminal of a cell to the negative terminal
  • This is opposite to the direction of electron flow, this is because conventional current was being put to use before the discovery of the electron

By definition, conventional current always goes from positive to negative (even through electrons go the other way)

• Current is measured using an ammeter
• Ammeters should always be connected in series with the part of the circuit you wish to measure the current through

An ammeter can be used to measure the current around a circuit and always connected in series

• In a circuit that is a closed-loop, such as a series circuit, the current is the same value at any point
  • This is because the number of electrons per second that passes through one part of the circuit is the same number that passes through any other part

• This means that all components in a closed-loop have the same current

The current is the same at each point in a closed-loop