Required Practical: Analysis & Purification of Water Samples (AQA GCSE Chemistry)

Required Practical 8: Analysis & Purification of Water Samples

Practical 8(a): Analysing and Purifying Water and making it Safe to Drink

Objective

• To determine the amount of dissolved solid in samples of water

Hypothesis

• Analysis of the pH and dissolved solids of water samples can help determine the regions the water comes from

Materials

• Water samples A, B, C and D

• Universal indicator paper

• Mass balance

• Evaporating basin

• 25 cm³ graduated cylinder

• Bunsen burner, tripod & gauze

Practical tip

Don’t overheat during step 4 as you run the risk of thermally decomposing some of the solids, leading to erroneous results

Method

1. Use the universal indicator paper to determine the pH of the water sample

2. Accurately weigh an empty evaporating basin to two decimal places

3. Add 25 cm³ of water sample A into the evaporating basin

4. Heat the evaporating basin on a tripod and gauze using a Bunsen burner until the solids start to form and the majority of water has evaporated

5. Leave for the remaining water to evaporate off

6. Weigh the cooled evaporating basin again and calculate the mass of the solids that were dissolved in the water.

Results

Record your results in a suitable table

Evaluation

• The results could be compared to the national water safety levels and by analysis the regions of each sample could be deducted e.g. region of high acid rain, water from a salt water supply etc.

Conclusion

• The amount of dissolved solids in water can be determined and is a useful indicator of water quality

Required Practical 8(b): To Purify a Water Sample by Distillation

Objective

• To separate pure clean water from a sample containing water and other substances

Hypothesis

• A simple distillation apparatus can be set up separate pure water from a mixture of water and unwanted substances

Materials

• 10 cm³ of water sample A

• Bunsen burner

• Tripod

• Gauze

• Heatproof mat

• Clamp and clamp stand

• Conical flask with delivery tube and bung

• Boiling tube

• Ice bath

Simple distillation apparatus

Diagram showing the apparatus to set-up for a simple distillation experiment

Practical Tip

The delivery tube must sit above the filtrate level to prevent cold water being sucked back up the delivery tube after separation, which would break the hot glass

Method

1. Add the water sample to the conical flask and set up the apparatus for distillation as shown in the diagram

2. Heat the water using the Bunsen burner until boiling occurs

3. Reduce the heat so that the water boils gently for some time

4. The distilled water will collect in the cooled test tube

5. Collect about 2 cm depth of water in this way, then stop heating

6. Analyse the water you have distilled by determining its boiling point

Results

• Distillate of pure clean water

Evaluation

• The pH of the water can be tested as well as its boiling point

Conclusion

• Simple distillation can be used to produce pure water from a sample of impure or contaminated water