Materials (OCR AS Physics)

Exam Questions

24 mins14 questions
11 mark

One end of a spring is fixed and a force F is applied to its other end. The elastic potential energy in the extended spring is E. The spring obeys Hooke’s law.

What is the extension x of the spring?

  • x = E over F

  • x = F over E

  • x = fraction numerator 2 E over denominator F end fraction

  • x = F over 2 E

Did this page help you?

21 mark

Four materials A, B, C and D have the same length and cross-sectional area. The force against extension graph for each material up to the breaking point is shown below.

q2-paper-1-june-2017-ocr-a-level-physics

Which material is brittle and has the greatest ultimate tensile strength?

    Did this page help you?

    31 mark

    The flat end of a uniform steel cylinder of weight 7.8 N is glued to a horizontal ceiling. The cylinder hangs vertically. The breaking stress for the glue is 130 kPa.

    q6-paper-1-june-2017-ocr-a-level-physics

    The glue only just holds the cylinder to the ceiling.

    What is the cross-sectional area of the cylinder?

    • 6.0 × 10−2 m2

    • 6.0 × 10−5 m2

    • 1.7 × 10−2 m2

    • 1.7 × 101 m2

    Did this page help you?

    1
    Sme Calculator
    1 mark

    A tensile force of 4.5 N is applied to a spring. The spring extends elastically by 3.2 cm.

    What is the elastic potential energy of the spring?

    • 0.072 J

    • 0.14 J

    • 2.4 J

    • 14 J

    Did this page help you?

    2
    Sme Calculator
    1 mark

    A graph showing the variation of the stress σ with strain ε for a material is shown below.

    q12-h556-01-qp-june-2019-ocr-a-level-physics

    What is the Young modulus of the material?

    • 6.0 × 104 Pa

    • 1.2 × 109 Pa

    • 8.0 × 1010 Pa

    • 1.2 × 1011 Pa

    Did this page help you?

    3
    Sme Calculator
    1 mark

    A student performed an investigation into how the mass added to a spring affected its length when stationary.

    A sample of the student’s results is shown in the table below.

    Mass / kg

    Length of spring / m

    0.30

    0.10

    0.60

    0.14

    The spring obeys Hooke’s law.

    What is the spring constant of the spring?

    • 7.5 N m-1

    • 42 N m-1

    • 74 N m-1

    • 147 N m-1

    Did this page help you?

    4
    Sme Calculator
    1 mark

    Spring A has a spring constant k.

    Spring B has a spring constant 2k.

    When a mass of m is hung from the bottom end of spring A, the elastic potential energy in the spring is E.

    A mass of 2m is hung from the bottom end of spring B.

    What is the elastic potential energy stored in spring B?

    • E

    • 2E

    • 4E

    • 8E

    Did this page help you?

    5
    Sme Calculator
    1 mark

    One end of a wire is fixed to a ceiling and a mass is suspended from its other end causing it to extend.

    The wire does not pass its limit of proportionality.

    Which of the following changes to the wire, made independently, would result in a greater store of elastic potential energy in the wire?

    • Increasing the Young Modulus of the wire’s material.

    • Decreasing the original length of the wire.

    • Decreasing the mass attached to the wire.

    • Decreasing the cross-sectional area of the wire.

    Did this page help you?

    1
    Sme Calculator
    1 mark

    A spring is stretched by hanging on it a variable mass m. The mass m is always at rest.

    The spring obeys Hooke’s law.

    What is the relationship between the elastic potential energy E in the spring and the mass m?

    • Em–1

    • Em–2

    • Em

    • Em2

    Did this page help you?

    2
    Sme Calculator
    1 mark

    The force F against extension x graph for a material being stretched is shown.

    q13-paper-1-nov-2021-ocr-a-level-physics

    What is best estimate for the energy stored in the material when the extension is 10 mm?

    • 0.07 J

    • 0.10 J

    • 0.13 J

    • 0.20 J

    Did this page help you?

    3
    Sme Calculator
    1 mark

    The table below shows some data on two wires X and Y.

    Wire Young modulus of
    material / GPa
    Cross-sectional
    area of wire / mm2
    X 120 1.0
    Y 200 2.0

    The wires X and Y have the same original length. The tension in each wire is the same.
    Both wires obey Hooke’s law.

    What is the value of the ratio fraction numerator e x t e n s i o n italic space o f italic space X over denominator e x t e n s i o n italic space o f italic space Y end fraction ?

    • 0.30

    • 1.7

    • 2.0

    • 3.3

    Did this page help you?

    4
    Sme Calculator
    1 mark

    Wire P has radius r, and is put under a load F. Wire Q is put under the same load F. and its radius is a third of wire P

    What is the value of the ratio begin inline style sigma subscript P over sigma subscript Q end style?

    • 1 third

    • 1 over 9

    • 3

    • 9

    Did this page help you?

    5
    Sme Calculator
    1 mark

    Spring X and Spring Y are connected in series. Spring X has force constant k and Spring Y has force constant 2 over 3k Force F is exerted onto the springs and the total extension on the springs is 0.1 m.

    What is the force exerted on the springs?

    • F equals 1 over 25 k

    • F equals 2 over 5 k

    • F equals 4 k

    • F equals 3 over 5 k

    Did this page help you?