Young Double-Slit Experiment (OCR A Level Physics)

Revision Note

Test yourself
Katie M

Author

Katie M

Last updated

Young Double-Slit Experiment

  • For two-source interference fringes to be observed, the sources of the wave must be:
    • Coherent (constant phase difference)
    • Monochromatic (single wavelength)

  • When two waves interfere, the resultant wave depends on the phase difference between the two waves
    • This is proportional to the path difference between the waves which can be written in terms of the wavelength λ of the wave

  • As seen from the diagram, the wave from slit S2 has to travel slightly further than that from S1 to reach the same point on the screen
    • The difference in this distance is the path difference

Path difference equations, downloadable AS & A Level Physics revision notes

Path difference of constructive and destructive interference is determined by wavelength

  • For constructive interference (or maxima), the difference in wavelengths will be an integer number of whole wavelengths
  • For destructive interference (or minima) it will be an integer number of whole wavelengths plus a half wavelength
    • n is the order of the maxima/minima since there is usually more than one of these produced by the interference pattern

  • An example of the orders of maxima is shown below:

Max and min interference pattern, downloadable AS & A Level Physics revision notes

Interference pattern of light waves shown with orders of maxima

  •  n = 0 is taken from the middle, n = 1 is one either side and so on

Young's Double Slit Experiment

  • Young’s double-slit experiment demonstrates how light waves can produce an interference pattern
  • The setup of the experiment is shown below:

Double slit experiment diagram, downloadable AS & A Level Physics revision notes

Young’s double-slit experiment arrangement

  • When a monochromatic light source is placed behind a single slit, the light is diffracted producing two light sources at the double slits A and B
  • Since both light sources originate from the same primary source, they are coherent and will therefore create an observable interference pattern
  • Both diffracted light from the double slits create an interference pattern made up of bright and dark fringes

Wave Nature of Light

  • Interference is a confirmation of the wave-nature of light
  • Newton initially proposed that visible light is a stream of microscopic particles called corpuscles
    • However, these corpuscles could not explain interference or diffraction effects, therefore, the view of light as a wave was adopted instead

  • Not long after, Huygens came up with the original Wave Theory of Light to explain the phenomena of diffraction and refraction
    • This theory describes light as a series of wavefronts on which every point is a source of waves that spread out and travel at the same speed as the source wave
    • These are known as Huygens’ wavelets

Huygens Wavelets, downloadable AS & A Level Physics revision notes

Huygen's wavelets shown by two wavefronts AB and CD

Examiner Tip

The path difference is more specifically how much longer, or shorter, one path is than the other. In other words, the difference in the distances. Make sure not to confuse this with the distance between where the two paths begin

Double-Slit Equation

  • The fringe width, wavelength of the light, distance between the slits or the distance from the slits to the screen can be calculated using the double-slit equation:

Double slit equation, downloadable AS & A Level Physics revision notes

Double slit interference equation with a, x and D represented on a diagram

  • This equation is only when a << D
  • The interference pattern on a screen will show as ‘fringes’ which are dark or bright bands
    • Constructive interference is shown through bright fringes with varying intensity (most intense in the middle)
    • Destructive interference is shown from dark fringes where no light is seen

  • A monochromatic light source makes these fringes clearer and the distance between fringes is very small due to the short wavelength of visible light

Worked example

A laser is placed in front of a double-slit as shown in the diagram below.WE - Double slit equation question image, downloadable AS & A Level Physics revision notesThe laser emits light of frequency 750 THz. The separation of the maxima P and Q observed on the screen is 15 mm. The distance between the double slit and the screen is 4.5 m.Calculate the separation of the two slits.

Examiner Tip

Since a, x and D are all distances, it's easy to mix up which they refer to.Labelling the double-slit diagram in the way given in the notes above will help to remember the order i.e. a and x in the numerator and D underneath in the denominator.

You've read 0 of your 10 free revision notes

Unlock more, it's free!

Join the 100,000+ Students that ❤️ Save My Exams

the (exam) results speak for themselves:

Did this page help you?

Katie M

Author: Katie M

Expertise: Physics

Katie has always been passionate about the sciences, and completed a degree in Astrophysics at Sheffield University. She decided that she wanted to inspire other young people, so moved to Bristol to complete a PGCE in Secondary Science. She particularly loves creating fun and absorbing materials to help students achieve their exam potential.