Making Simple Cells (AQA A Level Chemistry)

• Simple cells can be used to investigate the effect of different electrode combinations on the EMF produced by an electrochemical cell

Key steps in the procedure

• The metal foil electrodes are cleaned using sandpaper and rinsed under a cold running tap
• The metal foil is immersed into a solution of its ions and can be secured in place by folding the end over the lip of the beaker
• A strip of filter paper is soaked in saturated potassium chloride or nitrate solution to form the salt bridge; the ends of the strip are then immersed in metal ion solutions
• The EMF of the cells can then be measured and compared to the expected voltage from standard electrode potentials

Measuring the EMF of different metal electrode combinations

Measured EMF specimen results table

• Measured results in the lab are generally lower than calculated results from data tables
• This is usually because non-standard conditions have been used

• The same procedure as the previous experiment can be used to investigate the effect of concentration on the EMF of an electrochemical cell
• At the end of the first measurement one of the solutions is diluted by a factor of ten by taking 25 cm³ of the solution and diluting it to 250 cm³ with distilled water using a large measuring cylinder
• The EMF is measured and the process is repeated until a total of five dilutions have been carried out

Practical tip

• Although in principle any pair of metals be used its best to use metals with a sufficiently large difference in electrode potential for this experiment so the range of results in meaningful

Concentration and EMF specimen results table

Analysis

• A graph can be plotted of EMF versus dilution factor:

Graph of EMF against dilution for an electrochemical cell

• The graph shows that the cell EMF is proportional to the dilution to the power of ten
• Decreasing the concentration of the solution reduces the cell EMF because there are fewer particles to react

Further investigations

• The same equipment can be used to investigate the effect on cell EMF of changing the temperature, the spacing between the electrodes and even the depth of the electrodes